lathe elevation

[greitz]

I'm finding that the Shopsmith is a bit short for me in lathe mode. At least my back thinks so, or maybe it's just a lack of proper technique.:D Anyway, has anyone put his/her Shopsmith up on blocks? Did you bolt the blocks to the floor? Any special techniques for minimizing vibration? Thanks for the help!

Gary

[Bruce]

I have heard of people elevating the SS for lathe operations. Personally, unless you plan to use it exclusively as a lathe, I wouldn't do it. But that's just me. Have you considered getting an adjustable stool? I don't see why you couldn't do most everything sitting down that you do standing up. Has anyone tried it?
Another option would be to build an elevated platform for the SS with a removable insert in front that would be removed when using the lathe mode and replaced when using other modes. It would have to be a sturdy platform to keep everything stable and in alignment, but I would think it could be done. I'm 6'2" myself and can empathize with your back. :) If I had the space, I'd consider the platform myself. It seems you could build the base with 2x6's on edge, like a wall lying down, say 12 inches apart with "cross studs" every 12 inches to make a checkerboard like base, then top it with 3/4 sub-floor grade plywood (maybe even two layers). Build a section of the base in front of the SS as a separate unit that can be removed for lathe work. This would effectively raise the SS 6 inches for us tall guys.

Bruce

[rflaherty]

I was thinking about the same thing a couple of weeks ago, Gary. At the Shopsmith Traveling Academy, the instructor suggested putting a length of 4x4 under each leg. I haven't tried that yet because then you could no longer use the retractable casters, which I find useful. I wrote Bob Folkerth and suggested Shopsmith offer replacement legs that were 4-6" higher than the original legs, but haven't heard back yet on the feasibility of that. I am thinking about building some kind of extension to the legs (either at the top of the legs or at the bottom of the legs) that would raise the entire machine but allow me to re-attach the retractable casters. Perhaps a U-shaped affair made from 3/4" plywood with cross-bracing would work. If you do elevate the machine, you might want to add some "outriggers" since you are raising the center of gravity of the machine which might make it tippy. Please let us know if you come up with any good ideas.

--Bob

[Nick]

Folks, I put my Shopsmith up on 4x4 blocks for lathe work. The late Rudy Osolnik, professor of woodworking at Berea College and a nationally renowned turner, put all 3 of his Shopsmiths on blocks. Jim McCann, our plant engineer and a master craftsman whose work has been published in dozens of books, including FW's Design Books, puts his up on blocks. It's a good solution.

With all good wishes,

[tchwrtr55]

Question: Is it not safer having wood spinning as low as possible (as low as an aching back will allow) than closer to your head? Just wondering.
Mark

[greitz]

I tried elevating the lathe on 4x4 blocks last weekend, and it's much better. Thanks for the help! On the other hand, now I don't have an excuse why the turnings don't turn out the way I think they should....

-Gary

[Bruce]

Now that you have it up on blocks, have fun cutting that plywood with the table saw! :)

[greitz]

Oh, well, I promised SWMBO that I'd actually put the new car in the garage every night, so I have to move the Shopsmith out of the corner every time I want to use it anyway. So I'll get lots of practice lifting it up on 4x4's.

Nick, if you guys want to make a "Lathe Lift-assist", I'll probably be your first customer.