Storing support legs and connector tubes

[chrispitude]

Hi all,

I made a little 2x4 thingy to mount on the wall and hold the support legs and connector tubes:

1857 (http://www.chrispitude.net/view.php?album=house/shopsmith&pic=IMG_2422.jpg&dispsize=1024&picindex=25&size=2)

I cut a piece of 2x4 19" long, which puts the stud attachment points 1.5" in from each end. I put some small broom clips 2.5" apart starting 1" in from the end to hold the connector tubes, and a single ladder hook between the two sections of clips to hold the support legs. The two 48" connector rods are currently in use on the Shopsmith, so their clips are empty.

The broom clips were too slippery to hold the metal connector tubes as they came, so I added some pieces of electrical tape to act as grips:

1858 (http://www.chrispitude.net/view.php?album=house%2Fshopsmith&pic=IMG_2424.jpg&dispsize=1024&start=0&picindex=26&size=2)

In retrospect, I probably should have mounted it a bit lower on the wall as it takes some effort to snap the connector tubes into the clips while reaching up so high. (I mounted it high to try to get it out of the way of swinging stock around, etc.) I'm sure the clips will expand a bit and this will become easier, but it's something I hadn't thought of.

- Chris

[wa2crk]

Chris;
I have been using the same clips for a few years now. Try mounting the clips so the tubes will be horizontal and they won't slide out. I used to hang my 510 tables to the wall with the same clips and the tables did NOT fall off the wall. I did this by securing piece of 3/8 plywood to the wall making sure that the plywood was secured to the studs so it would not flex. This system worked for several years until I upgraded to the 520 fence and rails

[chrispitude]

Ooh, I'd love to find a way to mount my 520 auxiliary tables on the wall! Any ideas there? :)

- Chris

[wa2crk]

Hi Chris;
Yes I do. I mounted my 520 tables using large hooks similar to cup hooks but larger, Space the hooks so that they go between the rails and the tables and they will hook onto the spacers that are behind the rails. Go to the SSUG.ORG website and go into the gallery section and look for pic of "Bill Van's shopsmith Wall". It almsot looks like the tables are floating on the wall. You can also use large "L" hooks sold at most ACE Hardware stores and also hang the 520 fence on the wall.
Bill V

[cincinnati]

Ooh, I'd love to find a way to mount my 520 auxiliary tables on the wall! Any ideas there? :)

- Chris

Just a click away

http://www.shopsmith.com/itempics/sjpg/555d/555941s.jpg

http://www.shopsmith.com/ownersite/itemfind.htm?item=555941&Submit=Find+Item

[fjimp]

I liked the shopsmith solution for hanging my tables and legs so well I bought a second set for extra tables. Jim

[dusty]

I made mine. Need to rethink it now that I have the Crafter's Station Tables too.

[charlese]

I like my Shopsmith brackets quite well, after I got over the purchase price. Didn't have enough wall space for table mounting so did this - -
1864