dusty
02-09-2009, 04:38 AM
Thank you for the photo images. These make it so much easier to understand. And easier to understand why what is said is sometimes not understood.
This table is certainly a lot different than mine.
billmayo
02-09-2009, 09:58 AM
There are 3 extended edges on the original bandsaw table aluminum insert. When they become too loose, I lightly tap a center punch close to the edge in each of these 3 areas to tighten the insert.
If missing the insert, I use these inserts from Rockler. I used a flat block and sandpaper to level the insert with the table top.
25655 Zero Clearance Bandsaw Inserts (Set of 5), Delta $9.99 Pack
meredj
02-10-2009, 08:06 PM
Thanks everyone for the timely tips and great pic's. This is exactly what I needed.