Headstock Bearings

[johnmccrossen]

I would like to find out the bearing part numbers for the drive and idler shafts for the Mark V Model 500 headstock. I recently acquired an older Mark V from an estate. (1962 or 1963 vintage). It seemed to have a lot of vibration at higher speeds. I ordered and replaced both belts. When doing so, I noticed these felt a little rough. I do not see these bearings listed separatly on parts list for headstock. Any suggestions from rebuilders? Thanks,

[curly57]

Hey John!! do you still have the gilmer drive belt? if so you might think about upgrading to th v-drive, and a new quill. I have an old greenie, I upgraded mine and it runs real smooth.
Happy Woodworking and God Bless!!
Curly...

[johnmccrossen]

It's an anniversary model with 1 1/8 hp motor and poly v drive. Also was already upgraded to two bearing quill a few years ago. Thanks.