1 1/4 Saw Arbor Repair

[wholeshoe]

All

My new used shopsmith came with a all purpose blade and a 1 1/4 saw arbor.

Upon inspection of the arbor somone gauled it up and had for some reason tried to drill out the set screw and buggered the hole and threads all up.

Well tonight I finished drilling out and removing the set screw and then drilled the hole oversize to clean things up.

Does anybody see a safety reason with tapping the oversized hole and useing a bigger set screw to make the arbor useable again?

I have to purchase a tap and set screw but it should save the arbor from the trash can.

Wholeshoe

[billmayo]

All

My new used shopsmith came with a all purpose blade and a 1 1/4 saw arbor.

Upon inspection of the arbor somone gauled it up and had for some reason tried to drill out the set screw and buggered the hole and threads all up.

Well tonight I finished drilling out and removing the set screw and then drilled the hole oversize to clean things up.

Does anybody see a safety reason with tapping the oversized hole and useing a bigger set screw to make the arbor useable again?

I have to purchase a tap and set screw but it should save the arbor from the trash can.

Wholeshoe

The set screw in the arbor should be a Shopsmith item as it is softer than a normal set screw. A normal set screw (harder) will damage the quill shaft over time. I believe a tap and set screw will cost more than another used 1 1/4" saw arbor that are quite available. I trash any used arbors that shows any signs of damage just to be safe.

[wholeshoe]

Point well taken Bill.


I agree on the hardness and thats why I asked. I was looking for things I hadn't considered.

I have a brand new 5/8 arbor from Shopsmith coming in the mail so I am not out anything but time.

Art

[bucksaw]

The set screw in the arbor should be a Shopsmith item as it is softer than a normal set screw. A normal set screw (harder) will damage the quill shaft over time. I believe a tap and set screw will cost more than another used 1 1/4" saw arbor that are quite available. I trash any used arbors that shows any signs of damage just to be safe.

Bill...
Thanks good to know. I've replaced several SS set screws with after market stainless. I guess I'll be switching back.

Art...
You could drill and tape a new hole 180 degrees from the original. I can't imagine that it would alter the strength of the shaft itself.

[wholeshoe]

Great Point!!!

I think I might try that tonight.

I will report the outcome.

You guys are great!

Art

[wholeshoe]

I drilled it out at 180 degrees and tapped it and used the original set screw and it works great.

Thanks for the idea!

Art