tdubnik
04-01-2009, 07:53 AM
Thanks for the details. I would use some of your ideas for my cabinets. Did you prepare the edges of the MDF in any particular way before painting?
Did you prime the surfaces before the Krylon?
As you can see...I am getting ready!
Thanks again.
Ed
I put a chamfer on the edges and then did a lot of sanding. The edges aren't perfect as far as paint goes but they are pretty darn good. On the first cabinet I tried priming and then painting but it took the same number of coats as just painting without the primer. Since the cost was the same, I just skipped the primer on the later pieces.
The method I used for the MDF is as follows. Cut pieces to final size, chamfer the edges, sand all surfaces with 100, 150, 220 grit. Spray on 2 or 3 coats of paint just trying to get even coverage. Lightly sand again with 220 being careful not to sand through the paint. Spray on 2 more coats and call it quits. The pieces I've done so far have required about 30 cans of spray paint.
Did you prime the surfaces before the Krylon?
As you can see...I am getting ready!
Thanks again.
Ed
I put a chamfer on the edges and then did a lot of sanding. The edges aren't perfect as far as paint goes but they are pretty darn good. On the first cabinet I tried priming and then painting but it took the same number of coats as just painting without the primer. Since the cost was the same, I just skipped the primer on the later pieces.
The method I used for the MDF is as follows. Cut pieces to final size, chamfer the edges, sand all surfaces with 100, 150, 220 grit. Spray on 2 or 3 coats of paint just trying to get even coverage. Lightly sand again with 220 being careful not to sand through the paint. Spray on 2 more coats and call it quits. The pieces I've done so far have required about 30 cans of spray paint.