View Full Version : Screw extractor - Pilot hole size and which size extractor to use
Pages :
[
1]
2
3
4
5
6
7
8
mickyd
11-30-2009, 02:30 PM
I am having trouble locating on-line info on proper screw extractor procedure regarding what size pilot hole to drill and which size extractor to use on given size fasteners. I have #8 and #10 broken screws to remove. I can't locate the instruction that came with my extractor set. The style I have is like this (http://www.grainger.com/Grainger/items/2RUL8) and I have sizes 1 thru 5.
For a #1 the hole size is 5/64.
johnmccrossen
11-30-2009, 02:47 PM
Scroll down the catalogue page to see the drill sizes for your extractors.
http://www.grainger.com/Grainger/wwg/viewCatalogPDF.shtml?browserCompatable=true&adobeCompatable=true&toolbar=true&CatPage=2983
mickyd
11-30-2009, 03:22 PM
For a #1 the hole size is 5/64.
Scroll down the catalogue page to see the drill sizes for your extractors.
http://www.grainger.com/Grainger/wwg/viewCatalogPDF.shtml?browserCompatable=true&adobeCompatable=true&toolbar=true&CatPage=2983
I hope I am not making a mountain out of a mole hill here but you guys sure these numbers apply to spiral fluted style similar to the ones I have...(long gradual spiral vs. the steep one shown on the catalog page?)
Where you from John....catalogue?:D
That size is what mine says to use.
JPG40504
11-30-2009, 04:40 PM
:DJohn is from the olde school! Its a generational thingie. Like miter and mitre...
As far as the bit size is concerned. it needs to be big enough for the extracter to get a good bite, but not so big as to get into the hole threads.
WHY is a Bolt Expert asking this question? Maybe yours do not break or corrode? Yeah right!
The olde timey way was to drill it out and chase what is left with a tap. It still works, but does require accurate drill bit positioning!:eek:
If you have an acetylene cutting torch, there is a much quicker way!;)
mickyd
11-30-2009, 06:09 PM
:DJohn is from the olde school! Its a generational thingie. Like miter and mitre...
......
WHY is a Bolt Expert asking this question? Maybe yours do not break or corrode? Yeah right!
.......
Does the dental hygienist do the extractions? Does the structural design engineer set the charges for demolition? Is the tightrope walker versed in disassembly of the rigging and high wire platform?
Need I go on??:cool:
JPG40504
11-30-2009, 06:47 PM
Does the dental hygienist do the extractions? Does the structural design engineer set the charges for demolition? Is the tightrope walker versed in disassembly of the rigging and high wire platform?
Need I go on??:cool:
If I were a tight wire walker, I would be very involved in all aspects of my 'rigging'! Point made re other 'professions'. FWIW the demolition guru better have an expert knowledge of structural engineering if implosion is involved!