PDA

View Full Version : Shopsmith site

Pages : [1] 2 3
Ed in Tampa
05-10-2007, 11:42 AM
On the Shopsmith website there were instructions to align your 500,510 and 520. Adjusting the main table vertical, horizontal and parallel to the blade.

I know Nick put better instructions somewhere here in forum but I couldn't find them right off so I went to the SS website to look up something and noticed the instructions were gone or at least so well hidden I couldn't find them.

I wonder if they are going to be replaced? Perhaps with Nick's method.

I hope someone from SS see this and let us know the status of those alignment instructions. Ihave the owners manual but I liked to refer to the instructions online plus they had the latest info. I would really like to see Nick's instructions formally written up and posted on line.
Ed
dusty
05-10-2007, 11:53 AM
Ed

I agree; I believe the revised procedures (especially if accompanied by good photos) are much better than the "official procedure".

If you need what was on-line, I think I have it. I'll look (go hunting) and let you know.
dusty
05-10-2007, 01:09 PM
I suspect that the postings to which you refer (Nicks' included) are in

Shopsmith Forums/Main Woodworking Forum/ General Woodworking and

were posted on 11/06/06 and are titled "Main Table Ribbing".

Let me know if this is not what you were thinking of and I'll look further.
Ed in Tampa
05-10-2007, 01:54 PM
I suspect that the postings to which you refer (Nicks' included) are in

Shopsmith Forums/Main Woodworking Forum/ General Woodworking and

were posted on 11/06/06 and are titled "Main Table Ribbing".

Let me know if this is not what you were thinking of and I'll look further.

dusty
Yes that is it thank you!!!!!! Any idea what happened to the alignment procedures that use to be in the Shopsmith website?
Ed
dusty
05-10-2007, 02:51 PM
Ed

The procedure is in a document called MKVAssemblyPt2. The procedure is on pages 29to36.
charlese
05-10-2007, 04:21 PM
This Thread could have been named "Ask Dusty". Nice going dusty one!
No embaressment meant! Just think you are on the "Ball"!:D
Ed in Tampa
05-10-2007, 07:23 PM
Ed

The procedure is in a document called MKVAssemblyPt2. The procedure is on pages 29to36.


Dusty don't mean to be thick as a brick but where is MKVAssemblyPT2 found?

I know I saw that procedure on the Shopsmith site a while back but I can't find it anywhere, of course I usually manage to get lost in the Shopsmith Website. I don't know if it just me but I seems like I can never get to where I want to go right away I have to try this or try that before I find the right spot.
Ed
james.miller
05-10-2007, 09:11 PM
Hi,

I have tried to find the thread called Main Table Ribbing. Could you possibly post a link?

Thanks,

Jim in Tucson