Mounting bases

[fjimp]

Very nice. What are the dimensions on your stock? Also, it looks like there are holes drilled in the ends of the feel. Do you intend on bolting those down on a bench or shelf?

Yes sir nice work. This question is shared by my curiosity. The holders I built to store my sand flee didn't work well until bolted down. Now they are great. Okay mine aren't near as attractive as yours. Jim

[wlhayesmfs]

OK,, now I know one of my many next projects. I built a board on the wall from one of the other guys shops for all my ER parts now this will work great for the MKV extras.
Great job.
Thanks

[8iowa]

The overall dimensions are 10" x 8", which which is approximately the same as the aluminum bases. However, I did not angle the feet as on the aluminum base. The feet are countersunk and drilled to accept a 1/4" carriage bolt. I certainly recommend bolting the base down before attempting to mount a SPT.

As I built them I made some changes. I will now have to go back to my drawing and modify it. If you are going to mount a jointer with the dust port attached, you will have to cut a relief angle on the side of the cross piece in order to obtain clearance.

[charlese]

Nifty design, 8! Didja make an extra one to hole the extension table when not in use?