Rust removal

[ouagawood]

I just purchased a MarkV for a bargain. Of course, there is tremendous and I mean a boatload of rust on all of the tools. The unit was stored near the Texas coast and I need some advice on rust removal and salt deposits. I have tried Naval Jelly, works great on screws, but I need something for larger areas like the leg stands, way tubes etc.. SS Customer Help told me to use 0000 wool & WD40 & elbow grease. There has got to be something easier but not as damaging as sandblasting, right ? Help !!

[deathwish2]

Electrolysis would do the trick. You can probably use a large, sturdy (think Rubbermaid 'Brute' like janitors use) trash barrel for your 'vessel' . . . your way tubes will have to be done one end at a time, but other than that, all the pieces should fit in there.

More on the process over here . . .

http://wiki.owwm.com/ow.asp?RustRemovalByElectrolysis

It's worked wonder for me on some small projects.

[exodore]

I use the T-9 product from Boeshield. It does a great job.

http://www.boeshield.com/

[woodnyou]

I use an item called Abrasive Eraser. There is also a product from Klingspor called "Sandflex". It is a rubber block with grit built in. It is the same as the Abrasive Eraser. As you use it, it wears down. You can use it with a solvent if you with. Really works well on Cast tops too. Comes in three different grits.

[popstoyshop]

Hi Folks !

Here's my process: Spray on 3 or 4 coats of WD-40 letting each set over night. On the next day after the 3rd or 4th coat spray on a fresh layer of WD-40. This will loosen the first several coats. Then bring on the sandpaper. Depending on the amount of rust I start with 400 grit. Knock off the rough rust & then wipe the surface down. Spray on a light coat of WD-40 & use something like a 600 grit. Repeat with 1000 grit finish up with 1000 grit. Wash the surface down with meneral spirits, dry & apply several coats of wax letting each one harden before putting on the next coat.

Hope this helps.

Bill G.

[rcartmetal]

When the rust is really bad, you can first go over the surfaces with a single edge razor blade and scrape most of it off. This greatly reduces the amount of work the abrasives have to do.

[ericolson]

If you've a lot of rusty parts, I'd go with electolysis, as Mark (deathwish2) suggests.

[billmayo]

Here is the site that I got my information on electrolysis. It really works and A&H washing soda was available at local supermarkets.
http://antique-engines.com/electrol.asp

Bill Mayo