Craftsman Molding Set

[rwyoung]

I recently came across a 30+ year old Craftsman molding set that I bought new for my radial saw and never used (so it's still new). I didn't have a Shopsmith then, but do now (500, upgraded to a 510). First, is it advisable to use this set on the Shopsmith? Second, if it is okay to use what type of arbor and table insert should I have? Thanks in advance for the help.

[JPG40504]

I recently came across a 30+ year old Craftsman molding set that I bought new for my radial saw and never used (so it's still new). I didn't have a Shopsmith then, but do now (500, upgraded to a 510). First, is it advisable to use this set on the Shopsmith? Second, if it is okay to use what type of arbor and table insert should I have? Thanks in advance for the help.
Assuming a 5/8" arbor hole, - http://www.shopsmith.com/ownersite/catalog/ms_molderdadoarbor.htm

The ss insert should be ok! - http://www.shopsmith.com/ownersite/catalog/ms_tableinsert.htm

Before committing a sizable amount of $$, verify there are still additional knives available to fit it.

If you have never used one of these, do be careful!!!! They are a beast and shallow feed rates are recommended. They are capable of launching the workpiece similar to saw blade kickback.

That said, they do produce better results than the 'shaper' due to their increased cutting radius(the same thing that increases the launch probably and velocity).

[chucks]

When I was looking for one of these, I checked out the Sears version. They no longer had them available.....however there were many available on ebay for reasonable amounts(Knives). Have one, but have not used it yet. Planning on using it with my Sears table saw. Caution is the only thing I've heard about using them...I to,would be interested in any other advice.

[charlese]

...That said, (in theory) they do produce better results than the 'shaper' due to their increased cutting radius.

In engineering theory only! Bet no one can look at a finished product and tell what kind of machine produced it!;)

[JPG40504]

In engineering theory only! Bet no one can look at a finished product and tell what kind of machine produced it!;)

That would depend on how close one looked at it! I have noticed the difference!

Sharpness can also be 'seen'!

[burkhome]

Only got one thing to say...Heavy Duty feather boards
Roger

[burkhome]

Only got one thing to say...Heavy Duty feather boards. I broke 2 plastic ones and threw my workpiece. Thank God my dad taught me never to stand directly behind the workpiece that I was feeding into a table saw.
Roger

[JPG40504]

Only got one thing to say...Heavy Duty feather boards. I broke 2 plastic ones and threw my workpiece. Thank God my dad taught me never to stand directly behind the workpiece that I was feeding into a table saw.
Roger
FWIW You can delete the duplicate message under the 'edit message' function. You have to scroll down to find it, click delete this message(three places) and enter duplicate when prompted for a reason.

Add small cut depth to that only one thing to say!