HELP Pork Chop / Quadrant replacement HELP

[mountaingriller]

Today I received a new quadrant and control sheave assembly in the mail.
I've already taken off the old control sheave and replaced it with a new one.
I've taken the old quadrant off and can't remove it from the post/shaft. Is there a trick to removing it? I don't want to be to aggressive and break anything.

[bob84]

** IMHO **
Maybe you already did this, but before you install the Pork Chop to the whole speed adjustment quadrant, just a suggestion of checking into Mr. Bill Mayo's modification of this part. I cannot see how you would have a problem with the Pork Chop again. Mr. Mayo does not rely on the simple roll pin.
I think he has documented is idea on this forum.

[JPG40504]

Today I received a new quadrant and control sheave assembly in the mail.
I've already taken off the old control sheave and replaced it with a new one.
I've taken the old quadrant off and can't remove it from the post/shaft. Is there a trick to removing it? I don't want to be to aggressive and break anything.
The quadrant is secured to the arms on the speed control by a roll/spring/tension pin. It must be driven out from one end. The arm on the opposite end MUST be backed up and secured so as to not bend/break it(the arm). Whatever backs it up must allow the pin to exit the arm. Gently(just enough force to move it) is best.

To install the new quadrant, the pin must again be driven, but this time in rather than out(again backing up the opposite arm).


IF you have removed the quadrant and the pin IS still in it, the arm(s) are probably bent. Straightening them is best done with the quadrant(new) in position(with pin if possible) and squeeze the arms together with a vise(it moves incrementally and prevents sudden movement which may cause breakage). A c-clamp may work if used VERY CAREFULLY.

Try to bend the arms so the wormgear is centered over the quadrant gear.


Do proceed cautiously!!!

[mountaingriller]

Thanks for the suggestions - I used some liquid wrench and let it rest a few minutes - I cut the end off of a large nail and used the nail to drive the roll pin through - it's all back together now. The speed dial is hard to turn BUT otherwies the SS works great now!! I'm a happy camper now.

[JPG40504]

Thanks for the suggestions - I used some liquid wrench and let it rest a few minutes - I cut the end off of a large nail and used the nail to drive the roll pin through - it's all back together now. The speed dial is hard to turn BUT otherwies the SS works great now!! I'm a happy camper now.

It should not turn 'hard' unless slowing down too quickly.

[mountaingriller]

I think that the threads on the old quadrant assembly and the new "pork chop" don't gee haw - the threads on the old part must be slightly worn - That's the only thing that I can figure - they look OK - looking back I wish that I had replaced the entire quadrant assembly.
I used the SS for quite awhile today and it was quiet and smooth running, best in years!!

[JPG40504]

I think that the threads on the old quadrant assembly and the new "pork chop" don't gee haw - the threads on the old part must be slightly worn - That's the only thing that I can figure - they look OK - looking back I wish that I had replaced the entire quadrant assembly.
I used the SS for quite awhile today and it was quiet and smooth running, best in years!!

It is the quadrant gear that takes the brunt of the wear! Methinks perhaps the clearance has been reduced during either the previous wear or driving the pin out/in. Hopefully it will 'loosen up' over time!

[mountaingriller]

OK, I can live with it being hard to turn (hopefully it will loosen up with use)as long as it runs AND it is running sooo much better - sounds like a new machine!! I bougbt the SS in July 1981 and I can't live without it - last week I was wondering what I would buy to replace it with.