Opr

[dusty]

If you have been waiting, it has happened. The OPR is now on sale but from only three more days.

[fjimp]

If you have been waiting, it has happened. The OPR is now on sale but from only three more days.

Interesting timing of your post. Last evening my shop finally reached the point where unpacking the OPR reached the top of my list. I set it up on my shorty and am ready to use it. Fjimp:D:D:D

[nuhobby]

Hi,

Just thought I'd mention, even though the PowerPro (or even older MarkV) can put you in the capability to do some overarm routing jobs, the OPR still is the most flexible jig for that.
Specifically, you can tailor the OPR's distance from router-spindle to way-tubes, with several options in the mounting arm. The PowerPro will still have a fixed distance from spindle to way-tubes.
Also, the OPR gives a nice "one handed" way to plunge and depth-lock the router bit during the routing job. The PowerPro would still need 2 hands to carry out the plunge and depth-lock.

[tdubnik]

I have debated whether or not to get one of these as I have a very nice router table. I have started watching the video from the links in the sale announcement and all I can say is WOW.

I never realized the full capability of the OPR before. I think this would make a very nice addition to complement my router table. I had already planned to buy or build a horizontal router table but I found out the OPR can work in that mode too. This makes the buying decision much easier as I can save the money I would have spent on the horizontal table.

If you have any doubts about the OPR; spend a little time reviewing the video links and you'll be sold like I am.

[mbcabinetmaker]

I agree! It is the horizontal feature that I crave most. I have had this on my shopping list every since it was released and it keeps getting bumped but the next time it goes on sale maybe I'll be able to swing it. For now I am Festool poor!:D :D

[tryinhard]

Also, the OPR gives a nice "one handed" way to plunge and depth-lock the router bit during the routing job. The PowerPro would still need 2 hands to carry out the plunge and depth-lock.

Seems to me you shouldn't need two hands. Set the depth-lock position before beginning. Then tighten down the quill lock until there is just enough tension so you can extend the quill but it holds its position when you let go of the handle. You now only need one hand to lower the bit into the work.

[tdubnik]

I have a question about the OPR and templates/guide pins.

I see that the OPR comes with a 1/2" guide pin as the largest size. Let's say that I want to pin route a serving platter and use a 1" bowl bottoming bit. Can I just adjust my template 1/4" smaller to route the recess in the platter or should I make a 1" guide pin to match the router bit?

[Gene Howe]

I have a question about the OPR and templates/guide pins.

I see that the OPR comes with a 1/2" guide pin as the largest size. Let's say that I want to pin route a serving platter and use a 1" bowl bottoming bit. Can I just adjust my template 1/4" smaller to route the recess in the platter or should I make a 1" guide pin to match the router bit?

I'd make the pin. While your at it, make me one, too.
I was trying to figure a way to make a 1" dia. cap out of UHMW or even wood.
BTW, I'm serious about the pin. PM me if you can do it and I'll shoot you a check.
Thanks, tdubnik.