Tilting the Table 'Accurately'

[Stitch]

I don't have a Shopsmith Table Saw but I use one at a friends house. We need to rip some 4' pieces at angles other than those with fixed tilting table stops. These angles must be very accurate but we are having trouble tilting the table and locking it at the tilt angle without it changing. Does anyone have any advise for how this might be done more efficiently. We do use a digital gauge to measure the angles.

[charlese]

You can do a complete adjustment of the trunnions. OR-----(and I may get skewered for this suggestion, but it's what I'd do!) Remove the saw and saw guards. Get a pressurized can of silicone spray and using it from beneath the table, spray out the areas around the trunnions. When using the spray, tilt the table to both extremes. This should make the table tilt a lot easier and stay where you set it.

[JPG40504]

I don't have a Shopsmith Table Saw but I use one at a friends house. We need to rip some 4' pieces at angles other than those with fixed tilting table stops. These angles must be very accurate but we are having trouble tilting the table and locking it at the tilt angle without it changing. Does anyone have any advise for how this might be done more efficiently. We do use a digital gauge to measure the angles.
Which model ss are you using? There are two different tables. The size will distinguish which one it is. (14 x 18 3/8) or (17 1/2 x 22)

[dusty]

I don't have a Shopsmith Table Saw but I use one at a friends house. We need to rip some 4' pieces at angles other than those with fixed tilting table stops. These angles must be very accurate but we are having trouble tilting the table and locking it at the tilt angle without it changing. Does anyone have any advise for how this might be done more efficiently. We do use a digital gauge to measure the angles.I am uncertain as to what the problem is here. The protractor on the main table is reasonably accurate and you say that you are using a digital angle indicator which should further increase your ability to set the tilt where you need it.

The only thing I can think of, and this is a guess, is what Charlese has alluded to. The trunnions. If the system has not been properly aligned, tilting the table can be difficult due to binding of the trunnions.

The very first of the Shopsmith Sawdust Sessions (http://www.shopsmithacademy.com/SS_Archives/SS101/SS101_Alignment.htm)discusses table alignment and includes a procedure (the dollar bill trick) that may deal with your problem. I hope this helps. If not, please restate your problem and we'll try again.

[heathicus]

The way I take the question, what is happening is that when you set the table, the action of tightening the lock causes the table to move out of position. Is that correct?

If so, make sure you have 2 washers between the lock handle and the trunnion. What could be happening is the increased friction between the trunnion and lock handle causes the handle to "grab" the trunnion and turn it with the handle as it is tightened. This could still happen with just one washer, so make sure there are two. With a couple of washers between the handle and trunnion, any "grabbing" and movement should happen between the handle and washers and not be transferred to the trunnion.

If there are two washers there, maybe cleaning them up or putting some kind of lubricant on them would help?

[Stitch]

Yes, that better describes my problem. I can get the table positioned but cannot hold it accurately when I tighten it. This is very frustrating.

[dusty]

Aahh, that changes matters somewhat. Since you are unable to retain the table in the correct position when tightening the tilt lock, I just may have a fix. I'll have to take a couple photos but I'll post them here when I have them.

Thanks for the tip heathicus. I am not sure that I have two washers. I'll have to go look.

[heathicus]

Looking forward to seeing your fix, Dusty!