dusty
09-03-2007, 07:51 PM
Left, Right or in the middle. It really isn't a decision based on what one prefers. It's more a matter of which and how many woodworking functions you think are going to be happening all at the same time.
I joint almost everything that goes on the TS (left side is where the jointer goes).
I often go from horizontal mode to vertical mode and back several times during a project. Using the right side for the router table makes that difficult.
I think this all means I have to plan better. Everything that needs to be jointed needs to be done early in the project. First time the router is needed, jointer goes to the storage shelf and router table gets set up.
Guess I won't get rid of the old router table I could route some things on the old router table.:) :) :)
I joint almost everything that goes on the TS (left side is where the jointer goes).
I often go from horizontal mode to vertical mode and back several times during a project. Using the right side for the router table makes that difficult.
I think this all means I have to plan better. Everything that needs to be jointed needs to be done early in the project. First time the router is needed, jointer goes to the storage shelf and router table gets set up.
Guess I won't get rid of the old router table I could route some things on the old router table.:) :) :)